Best Heated Insoles for Work Boots

The pick for a full outdoor shift: Therm-ic Heat Kit with C-Pack 1300B

If you stand outside for a whole shift, buy the Therm-ic Heat Kit C-Pack 1300B set. Therm-ic rates the C-Pack 1300B batteries at up to 13 hours of heat, with three heat levels and Bluetooth control from a phone. The Heat Kit is a pair of thin heating elements that stick to the front of the insole already in your boot, under a top cover you trim to shape. Therm-ic’s US store lists the bundle at about $380.

Get Therm-ic Heat Kit C-Pack 1300B

The way it fits is what makes it the pick for work boots. Every other insole here except the Hotronic replaces the insole you stand on. The Heat Kit leaves your arch support and cushioning where they are, so a supportive aftermarket insole stays in the boot and still does its job. Therm-ic’s figures for the 1300 battery packs are 11-13 hours on level one, 5-7 hours on level two and 3-4 hours on level three, and about 6 hours to recharge from flat. Level one lasts through a 10-hour day plus the drive in and home.

Who should not buy it: anyone who works mostly indoors with short trips into the cold, and anyone who hates having anything strapped to the outside of a boot. The C-Pack batteries sit on the outside of the boot and connect to the heater with a cable. On a scaffold, in brush or on a ladder, tuck that cable under the pant leg or it can catch. At about $380 the set costs roughly three times the cheapest pair on this list, so it only pays when your shifts run longer than a built-in battery lasts.

How these heated insoles were ranked

These picks were not tested. The ranking comes from what the makers’ specifications and retail listings show, judged on six things that decide whether a heated insole works inside a work boot:

Get Fieldsheer Premium BT Heated Insoles Get Hotronic XLP 2C BT Get Fieldsheer Standard Heated Insoles

This list gives no scores. Owner reports of a battery dying early are common across the whole category and are covered in the runtime section below, not counted against one brand.

The rest, ranked, and who should buy each instead

2. Fieldsheer Premium BT Heated Insoles: the best pair with nothing outside the boot. Fieldsheer rates the Fieldsheer Premium BT Heated Insoles at up to 9 hours per charge. The battery is built in, the USB-C charging port is in the insole, a single heat zone sits under the toes, and you control them over Bluetooth through Fieldsheer’s MW Connect app. They trim to size, and Fieldsheer lists them at about $170. Buy these instead of the top pick if a cable over the boot collar is a snag risk where you work, or if your shift is 8 hours or shorter. Skip them if you work 12-hour days: 9 hours is the maker’s top figure, not a figure for a cold boot on a high setting.

3. ActionHeat Rechargeable Heated Insoles: the value pick. ActionHeat states up to 140°F and 8+ hours on low for the ActionHeat Rechargeable Heated Insoles. They have built-in batteries, three heat settings from a wireless remote, micro-USB charging, two sizes (S/M and L/XL) that cut to fit, and a 1-year warranty. The typical price is about $130 at ActionHeat and at farm and sporting retailers. Buy these if you want remote control for the least money. Skip them if you already own USB-C chargers for everything else, because micro-USB means carrying another cable.

Get ActionHeat Rechargeable Heated Insoles

4. Hotronic XLP 2C BT: the biggest battery, fixed to your own insole. Hotronic rates each Hotronic XLP 2C BT battery pack at 6000 mAh, with three constant heat settings plus a Power Boost setting, controlled by a button on the pack or by Bluetooth. Each pack measures 73 x 57 mm and weighs 5.3 ounces with its wire clip. The Custom version has heating elements with self-adhesive fabric covers that stick to your own insole. The Anatomic version comes with a pair of trim-to-size Anatomic insoles with integrated heating elements. REI lists the Power Set, which is the batteries and charger without heating elements, at about $300, so a first complete set costs more than that. Buy it if you want the Heat Kit’s keep-your-insole approach with a heavier battery. Skip it if the extra weight on the boot collar bothers you.

5. Fieldsheer Standard Heated Insoles: only if the others are out of stock. Fieldsheer gives the Fieldsheer Standard Heated Insoles three heat settings, a wireless remote, up to 7+ hours of warmth, a toe heat zone and Odorsheer antibacterial fabric, at a $129.99 list price. That price matches the ActionHeat, which ActionHeat rates for an hour longer.

Built-in battery or a battery pack on the boot

This choice decides more than the brand does. A built-in battery, as in the Fieldsheer and ActionHeat pairs, has nothing outside the boot and no cable to catch, and the insole charges like a phone. The cost is a fixed capacity: when it runs flat at hour 8 you have a cold, thin insole for the rest of the shift, and you cannot swap in a spare. The battery also adds thickness inside the insole, so the pair can feel firmer underfoot than a foam insole.

A separate pack, as with the Therm-ic C-Pack or the Hotronic XLP, moves the weight and bulk out of the footbed. The heating element under your foot can be only a few millimetres thick. The packs hold more charge (Hotronic’s XLP 2C BT pack is 6000 mAh), and a second pair of packs can be swapped in at lunch; charge them indoors, because Therm-ic says its charger is designed for indoor use and may not be exposed to damp surroundings, and Hotronic says its recharging cable is for indoor use only. Therm-ic also sells a larger C-Pack 1700B, rated at up to 17 hours, in a Heat Kit bundle listed at about $480 on its US store. That extra $100 buys about 4 more rated hours on low, which is worth it only for shifts past 12 hours.

In practice, a pack system suits long, static, cold work: surveying, flagging, yard work, ice-road and loading-dock shifts. A built-in pair suits work that moves between a heated cab or building and the outdoors, and work where anything on the boot collar is a hazard.

Runtime against a real shift

Every runtime here is the maker’s figure on the lowest setting, and the highest setting cuts it hard. Therm-ic’s own numbers for the 1300 packs fall from 11-13 hours on level one to 3-4 hours on level three, so a pack run on high from 6 a.m. is done before lunch. Read ActionHeat’s 8+ hours and Fieldsheer’s 9 hours the same way: those are low-setting numbers, and owners who run them on high report a fraction of that.

For a 10-hour day, the Hotronic XLP 2C BT, rated at 20-24 hours on setting 1, and the Therm-ic C-Pack 1300B, rated at 11-13 hours, cover the whole shift on their lowest setting. Fieldsheer lists both the Premium BT and the Standard at 7+ hours per charge (each page also says up to 9 hours per charge, without naming a setting), and ActionHeat rates its pair at 8+ hours on low. Hotronic says not to use its Power Boost (setting 4) for more than three minutes at a time because it may become too hot and may result in burns, and to set the heat before going into the cold rather than waiting until feet are cold; Therm-ic’s manual says not to allow its highest level to be switched on for more than a few minutes at a time, because it could produce too much heat and may cause burns, and to keep the C-Pack on low or moderate levels. Your foot and sock warm the boot over time, so you often need less heat after the first hour than at the start.

Charge time counts on back-to-back shifts. Therm-ic gives about 6 hours from flat for the 1300 packs, so pack batteries charged overnight are ready by morning. A built-in insole has to come out of the boot to charge, and leaving it out overnight also lets the boot dry, which is the real cause of many cold-feet mornings: a damp liner pulls heat out of the foot faster than any of these heaters puts it back.

Fit in a work boot: thickness, trimming, safety toes and EH ratings

A built-in heated insole replaces your factory insole, so take the original out. Stacking a heated pair on top of it raises your heel in the boot and squeezes the toes against the cap. With the Therm-ic Heat Kit or a Hotronic Custom element, the thin heater sticks onto the insole you keep, so the fit barely changes. If the boot is already snug with a thick sock, a toe-heating element pressed against the cap does less good than a half-size-larger boot with room for warm air.

Trim to the maker’s marked lines only, and never cut a Hotronic heating element or power cord: Hotronic says not to cut or kink either. In every pair here the heating wire sits under the toes, which is where the cold comes in from a steel or composite safety cap, and cutting past the lines can cut the circuit. ActionHeat’s two sizes (S/M and L/XL) and Fieldsheer’s size runs mean you choose the size that covers your boot size, then trim.

If your boots carry an electrical hazard (EH) or static dissipative (SD) rating under ASTM F2413, that rating was earned by the boot as built, not with a battery, wiring and heating element added inside it. Electricians and anyone near live circuits should ask the boot maker before adding any heated insole.

If your feet hurt more than they freeze, an ordinary insole is the better buy, and those are compared in best work boot insoles.

What is not worth the money, and what ownership involves

Not worth it: paying about $40 more for app control (about $170 for the Fieldsheer Premium BT against about $130 for the ActionHeat remote pair) if you work in gloves and keep your phone zipped away. A remote clipped inside a jacket pocket changes the setting faster. The Therm-ic C-Pack 1700B upgrade is not worth it either for shifts under 12 hours, because the 1300B’s rated 11-13 hours already covers them. Unbranded heated insoles that state no runtime, no setting temperatures and no warranty give you nothing to hold the seller to. ActionHeat states a 1-year warranty, and that is the minimum to expect.

Ownership comes down to charging and drying. Built-in pairs need their charging port kept dry and free of grit: Fieldsheer’s Premium BT port is USB-C, and the ActionHeat port is micro-USB. Pack systems need the cable connector checked for packed snow and road salt before you plug in. Pull built-in insoles out every night to charge, and the boot dries at the same time. Do not soak an insole that has a battery built in: Fieldsheer says to spot clean only and not fully submerge it in water, to dry it fully before turning it on, and to turn it off in case of excessive temperature and when it is not in use.

Heat on the feet carries a burn risk that the makers spell out. Hotronic’s instructions warn that its foot warmer can cause burns and that the risk rises with the temperature setting. Hotronic says to consult a physician before use if you have any condition, or take any medication, that increases skin sensitivity or reduces sensation to heat, naming calluses on feet, diabetes, cardiovascular problems, nervous system disorders, Raynaud’s syndrome and tetracycline. It does not recommend the foot warmer for infants, toddlers, children, or anyone who cannot recognise or act on the early warning signs of a burn. It says not to use it while sleeping, while consuming drugs or alcohol, with damp or wet socks, or with the heating element uncovered. If your foot gets hot or you feel any early warning sign of a burn, unplug the heating element and remove your foot immediately. Hotronic also warns that water around the electrical contacts may make the heating element hot at any setting and may result in burns: if a battery pack’s light stays on and cannot be turned off, unplug the heating element, remove your foot, and dry the pack and plugs before using it again. It says non-Hotronic look-alike components may be unsafe and may result in burns. Hotronic adds that using the foot warmer does not assure that freezing or frostbite of the foot will not occur. Therm-ic says anyone who has problems sensing hot or cold objects, such as diabetics, should consult a doctor before using its heater at all, and should check their feet regularly for reddening because excessive heat over prolonged periods can lead to burns. It says children may use it only under adult supervision, and that a heated sock and a heated insole must never be used together.

FAQ

Which heated insoles last a full 10-hour work shift?

Of the picks here, two pack systems are rated for more than 10 hours on their lowest level: the Hotronic XLP 2C BT at 20-24 hours and the Therm-ic C-Pack 1300B at 11-13 hours. The built-in pairs are rated at up to 9 hours (Fieldsheer Premium BT), 8+ hours (ActionHeat) and 7+ hours (Fieldsheer Standard), all on low. On high settings every one of them lasts a fraction of those figures.

Can I keep my own work boot insole and still add heat?

Yes. The Therm-ic Heat Kit is a set of thin heating elements that stick to the top of your existing insole under a cover you trim to shape, and Hotronic’s XLP 2C BT Custom has elements with self-adhesive covers that fix to your own insole. Both run from battery packs on the outside of the boot. Built-in pairs such as ActionHeat and Fieldsheer replace your insole instead.

Are heated insoles safe in steel-toe or EH-rated boots?

A heater under the toes helps with the cold a steel or composite safety cap lets in, and the safety cap itself is unaffected. An electrical hazard or static dissipative rating under ASTM F2413 applies to the boot as built, though, not with added wiring and a battery. If you work near live circuits, ask your boot maker before adding any heated insole.